Cancer Awareness Jewelry Ideas


1. Attach the preferred charms to the split rings already included on the bracelet.

2.Remove the small jump rings that come previously attached to the other charms using the needle nose pliers..

3.Using needle nose pliers, attach the charms with the 6mm jump rings onto the bracelet.

Materials for Bracelet:
  • 1 - Believe Star Charm (C2004)
  • 2 - Silver Ribbon Charm (C2060)
  • 2 - Silver Heart Charm (C1062)
  • Beads
  • Toggle Clasp
  • Beading Wire
  • Wire Cutters
  • 2 - Crimp Beads
  • Needle Nose Pliers

Materials for Earrings:

  • 2 - Silver Ribbon Charms (C2060)
  • 1 - Pair of French Hooks
  • 4 - 3mm Silver-plated Corrugated Beads
  • 2 - 5mm Pink Beads
  • 2 - 7/8 inch Eye Pins
  • Needle Nose Pliers
  • Round Nose Pliers


Steps for Bracelet:

Step 1: Cut wire 2 inches longer than desired bracelet length. Loop one end of beading wire through a crimp bead and then either directly onto one side of the toggle clasp, or onto a split ring. Thread the beading wire back through the crimp bead and flatten with the pliers.

Step 2: String beads. Use the steps above to attach the other part of the toggle clasp and end the bracelet.

Step 3: Using the 4mm jump rings that come on the charm, use the needle nose pliers to attach the charms around the bracelet.

Steps for Earrings:

Step 1: Thread 1 3mm silver bead, one pink bead, and one silver bead onto an eye pin. Using the needle nose pliers, bend the excess pin at a 90 degree angle.

Step 2: Grab the tip of the bent pin with the round nose pliers and curl the end by rotating the pliers. This will create the other eye.

Step 3: Remove the jump ring that comes attached to the charm. Open one eye on the eye pin, put on the charm, and close the eye.

Step 4: Attach one French ear wire by using the method above.

Step 5: Repeat steps 1 - 4, for the other earring.

Click here for your Awareness Charms