|
1. Attach the wire to
the jump ring on one end of the toggle clasp, by using the crimp bead and
crimpers.
2. Take a head pin and
string one emerald glass bead. Using the round pliers, create a loop. Make
four more of these.
3. String one snake tube
bead, a 3mm silver-plated fluted bead, the head pin with emerald glass bead,
one 6mm beehive coil bead, and another 3mm silver-plated fluted bead. Add
the gingerbread girl charm.
4. Continue by adding
another snake tube bead, a red glass bead, a snake tube bead, 3mm fluted
bead, another emerald bead on the head pin, a 4mm beehive coil bead, and the
Christmas tree charm.
5. Continue stringing
until you achieve the desired length or finish off the beads.
6. Leaving 2 inches of
wire, string a crimp bead and then loop the wire through the other toggle
piece. Thread the wire back through the crimp bead and pull the wire with
the pliers until the beads are snug. Crimp the bead with the crimpers, and
thread the remaining wire back through the beads.
|
|
1. Take the eye pin
and put two silver fluted beads and one ruby glass bead on it as shown.
Using the needle nose pliers, bend the extra pin to a 90 angle. Use the
rounded pliers to create a loop that is parallel to the other loop.
2. Attach the reindeer
charm on one loop. Attach the French hook wire to the other end.
3. Repeat with the
other earring.
|
|
1. String 4 of the 3mm
fluted beads, alternating with the "E" beads as shown above. After the
fourth fluted bead, string one pointed square beads.
2. Continue adding 4
more fluted beads, alternating with the "E" beads as shown.
3. Close the crimp
hoops, securing the wire by squeezing with the pliers.
4. Attach the dove
charm with the jump ring to the small loop on the crimp hoops.
5. Attach the French
hook wires to the crimp hoop.
6. Repeat steps 1-5
for the other earring. |
